Know before you go

STEP 1 - Installation and Wiring

STEP 1 - Installation and Wiring

All of our timers can be mounted on a standard DIN-rail that is commonly used in residential or industrial applications.
In case you would not like to go with the DIN-rail flow, we offer special mounting plates that let you snap our devices on any kind of surface.

Once your timer is in place, start wiring the time delay relay as shown in our datasheets. Make sure that our devices are installed by authorized and certified personnel only.

The integrated SPDT relay output provides sufficient switching capacity for common industrial solutions.

STEP 2 - Choose your Function

STEP 3 - Choose your Time Range

STEP 3 - Choose your Time Range

Our multifunctional time delay relay allows you to adjust time ranges from seconds (s) to minutes (m) and hours (h).

The general time delays can be set from as low as 0.05s up to 100h.

In this step the time value is set to the preferred range with the rotary knob in the middle.



You would like to set your ON-DELAY to 6 hours (h). In this case set the rotary knob to “10h“.

Depending on your preferred value, you can switch between different timing ranges, like 1h, 10h or 100h in this example.

STEP 4 - Set Time

All set.

All set.

Once in operation, the time delay relay indicates several status conditions.

The status LEDs include:

  • Indication of supply voltage, green LED U/t is on
  • Indication of timing period, green LED U/t is flashing
  • Indication of relay output, orange LED ON or OFF


For further informations please check out the datasheet or consult your local sales representative.

Can I help you?

We are happy to cross over any competitor products for you. Please don't hesitate to contact me!
If you are unable to access the TELE Website, please send an email to one of the following contacts:

Technical requests:


Other requests:

Requests in regards to USA:

Or please use one of the following browsers!