TELE solutions in the real world - everything from A to Z
119 Case Studies
No entries found.
Thrust overload protection, coal unloading facility
Das Schubniveau, das ein elektromechanischer Antrieb entwickelt, steht in direktem Zusammenhang mit der elektrischen Leistungsaufnahme des Stellmotors. Durch…
Energy measurement for wind generators and small hydropower plants
Energy measurement for wind generators and small hydropower plants S6XM50A1000VM und S9XM300A1000VM Wind turbines or small hydropower plants are confronted with…
No flooding in the underground car park
The V4LM level monitor controls the entry of water into underground car parks and activates pumps to pump out the water as well as issue alarm signals as…
Charge measurement for energy storage devices
Save and fully isolated measurement of DC energy packs VEO Series V4IA100A 24-240V AC/DC For battery power packs in energy storage devices, peak power systems…
Der Energy Meter und Messwertumformer S9XM300A1000VM misst alle essenziellen elektrischen Parameter von Antrieben in der Automatisierungstechnik komplett…
Leak detection, defective pipes
V4LM4S30 24–240V AC/DC Artikel Nr.: 2104500 Leaks in water tanks or pipes for water, water-soluble liquids or cleaning lyes usually cause serious damage in…
With the TELE voltage monitoring device critical electrical states such as undervoltage, asymmetry and phase failure are easily detected.
Automatic fan control of drying chamber
The monitoring relais E3IF500mAAC20 controls automatic start/stop of auxiliary drives.
Fan monitoring for paint or sandblast booth
The TELE load monitor GAMMA G2CU400V10AL10 recognizes faulty operating conditions of fan motors and triggers the delay timer.
Level monitoring of electroplating tanks
The TELE monitoring relais G2LM20 von TELE detects the level of chemically aggressive, conductive liquids in containers
LED lamp monitoring
LED lamps nowadays are widely used in buildings, industrial environment, plants and public places. The challenging task to monitor changes in the low lamp…
Monitoring of pumps & valves
The Watchdog relais E1ZMWt10 detects water flow pulses to make sure that pumps and valves work properly
Prevent elevator shaft from water damage
The TELE Pegelmonitor V4LM4S30 protects elevators and escalators from water water damage.
Controlling electric heater elements and infrared lamps
The combination of OVP1 and the space saving thyristorstack TST1-230 is perfect for controlling IR lamps and fast reacting heaters.
Catching the sun!
The most important but also basic task for a PV installation is to get the most solar energy converted by the modules. With just two inputs and NO CONTACTORS…
Cleaning the pump impeller through intelligent motor control
Soft starter Christian P-4.0 with integrated forward/reverse control enables automatic cleaning in closed pump system
Pump control to reduce water hammering in the pipe system
Christian P-4.0 with soft start and soft stop increases the water pressure in the pipe in a controlled way. The pump does not generate water hammering the pipes…
Automated roll gate/sliding gate control
Soft-starter CHRISTIAN P-4.0 with soft start/soft stop prevents the mechanics of roll gates from heavy stress.
Monitoring of a cold store door
This is designed to prevent the cold store door from being open for too long while the cooling continues to run.
Save stove shut down
Time relais avoids unsafe condition in case of impact button blockade E1ZM10 24-240 To avoid fire hazard, the stove in the shared kitchen of a residential home…