Train washing system
- Cleaning, Washing
- Industrial Plant
- Power reading converter
- The pressure applied by the cleaning brush in a train washing system should remain as constant as possible to ensure optimal cleaning.
- When the pressure changes, the power drawn by the brush motor also changes.
The use of a power measuring transducer forwards the power consumption of the brush motor to the PLC over a standard signal (4–20 mA), and the PLC then adjusts the position of the brush accordingly with an actuator.
- - Monitoring of the functioning of the system and the cleaning quality
- Indirect measurement outside of the wet area
- Very short reaction time
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Portable, 3-phase industrial vacuums that are supplied with power through a plug may not start when the phase sequence is incorrect or a phase has failed.
Level monitoring of electroplating tanks
The TELE monitoring relais G2LM20 von TELE detects the level of chemically aggressive, conductive liquids in containers
After the system is switched off, the extraction system should continue to run for a certain time to ensure that no sawdust remains on the machine.
Lathe chip conveyor
System shutdown in the event of overload and blockage.
Pulp production datacollection
Monitoring of the production line for cellulose fibre. The operating data for the conveyor belt drive motors must be collected and sent to the higher-level…
Pulp manufacturecurrent measurement
Multiple motors are controlled by a frequency converter. The frequency converter can only measure the total current, but not the power draw of the individual…