- Water & Waste
- Active power
- Prevention of filling a tank with air/monitoring a tanker at a minimum level.
- To prevent a tank from being filled with air, a tanker is monitored to ensure that its fill level does not fall below a minimum level when it is being unloaded. As soon as the throughput of the pump decreases, the pump is switched off by means of the underload monitoring function of the load monitor.
- - More reliable solution than level switch, as fluids in the tanker can slosh around too much
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Monitoring of supply pumps
Ensuring the correct rotation direction for the supply pump in a hydropower plant.
Fluid level monitoring
When the pools at a waste water treatment plant are filled to a constant level, this causes undefined states for the float switches (a “flutter state”).
Continuous operation detection
Preventing the destruction of a compressor due to continuous operation after an air hose becomes defective.
Pump control to reduce water hammering in the pipe system
Christian P-4.0 with soft start and soft stop increases the water pressure in the pipe in a controlled way. The pump does not generate water hammering the pipes…
Waste incineration system screw conveyor
Shutdown of the screw conveyor in the event of overload.
Short circuit monitoring
Pumps are monitored with PTC resistors or thermal contacts. When PTC resistors are used, the sensor cable should be monitored for short circuits. The available…