Supply voltage monitoring
- Energy distribution
- Monitoring the supply voltage of an office complex to detect a power failure.
- If the supply voltage falls below the fixed threshold of 0.85 times the nominal voltage, the device switches off and enables the emergency power system and the emergency lighting through the relay output in systems that comply with VDE 0108-100 and VDE 0100-718.
- - Safe and reasonably priced solution
This might be of interest for you
No entries found.
Current monitoring for pump stations
Plug-in monitoring relays are installed in the pump stations of many hydropower plants. These devices are intended to allow for quick and safe replacement in…
Monitoring of the operating state of the belt scraper. The belt scraper could get blocked. This can cause the drive chain to become damaged or break.
Load status monitoring
The rotor blades of a wind turbine have to be turned out of the wind in the event of a problem. A battery is used for this. Therefore, the battery must be…
Rotation direction monitoring for heat pumps
A heat pump should be protected against rotation in the wrong direction. If the phase sequence is incorrect, the pump must not be switched on. If a phase fails…
Peak load detection
An emergency power generator starts in the event of a mains failure.
Sewage plant rake drive
The goal is to monitor a sewage plant rake for overload, and to switch it off when it is blocked by large pieces of wood.