Pulp manufacturecurrent measurement
- Industrial Plant
- Multiple motors are controlled by a frequency converter. The frequency converter can only measure the total current, but not the power draw of the individual motors. Very low operating speeds must be realised.
- A G2IA15A 4…20mA current measurement module is installed ahead of each motor. The measured power draw is transmitted to a higher-level process control system in analogue form. This allows the motors to be monitored individually at the process level.
- - Very exact measurement at low frequency (up to 3 Hz)
- Exact monitoring of individual motors
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Power failure monitoring CNC milling machine
In order to detect momentary power failures in a CNC machining center, the system is equipped with the TELE V2UF230V10 voltage-drop detector.
Mobile communications transmitter station
System faults and failures in mobile communications transmitter stations as a result of poor power supply quality (undervoltage, phase failure) should be…
Industrial vacuum filter cleaning
The filters in industrial vacuums become clogged after a time. The vacuum is run in alternating suction and pressure mode to clean the filter.
Feed pump monitoring
The feed pump at a natural gas fuel station must be monitored for dry running. If no LNG is being pumped, the pump must be switched off.
Activation and deactivation of a uninterruptible power supply (UPS)
Automatic fan control of drying chamber
The monitoring relais E3IF500mAAC20 controls automatic start/stop of auxiliary drives.