Plastic contour cutting machine
- Product category:
- Timing Relays
- Processing machines
- V2ZA10 3MIN 24-240V AC/DC
- Data sheet:
- Switching on ventilation of a frequency-controlled drive motor on a contour cutting machine for plastic
- Additional ventilation for a frequency-controlled drive motor. The integrated ventilation is not sufficient at low frequencies (10 Hz), so an additional fan is used and is controlled by the V2ZA10 3MIN 24-240V AC/DC.
- - The cooling of the motor is ensured.
This might be of interest for you
No entries found.
Pipe system cleaning
Chemical deposits are to be removed from pipe networks mechanically by means of different compressed air and water pressure impulses.
Frequency converter control
A frequency converter controls a conveyor belt motor. The frequency converter is controlled by a 4–20 mA signal from a PLC. Monitoring of a 4–20 mA control…
Grapevine pest control
For pest control, a mechanical switch is actuated at each grapevine. The nozzle should then be activated for a certain time to spray the respective substance…
Short-circuit protectionfor the manufacture ofglass laboratory flasks
The short-circuit proof Gefran thyristor controller from TELE increases the availability of plant furnaces, such as those used for the manufacture of glass…
Circuit board cleaning
The pressure applied by the cleaning brush for cleaning circuit boards should remain as constant as possible to ensure optimal results.
Pulp manufacturecurrent measurement
Multiple motors are controlled by a frequency converter. The frequency converter can only measure the total current, but not the power draw of the individual…