Peak load detection
- Emergency Power
- Renewable Energy
- An emergency power generator starts in the event of a mains failure.
- The mains failure is monitored with a E1YU400V01. The tripping of the output relay starts the emergency power generator. Undesired voltage peaks result from the high load changes caused by the switching on and off of different consumers. The G2YM400VL20 reacts to the voltage peaks and switches off if necessary.
- - Detects mains failure
- Monitore undervoltage and overvoltage at the generator
- Protects consumers
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Energy measurement for wind generators and small hydropower plants
Energy measurement for wind generators and small hydropower plants S6XM50A1000VM und S9XM300A1000VM Wind turbines or small hydropower plants are confronted with…
Der Energy Meter und Messwertumformer S9XM300A1000VM misst alle essenziellen elektrischen Parameter von Antrieben in der Automatisierungstechnik komplett…
Start-up suppression for DC motors
The starting resistor of a DC motor has to be bypassed for regular operations, but no additional control voltage is available.
Current monitoring for pump stations
Plug-in monitoring relays are installed in the pump stations of many hydropower plants. These devices are intended to allow for quick and safe replacement in…
Load status monitoring
The rotor blades of a wind turbine have to be turned out of the wind in the event of a problem. A battery is used for this. Therefore, the battery must be…
Emergency power monitoring
Phase failure for the operating theatre ventilation systems in hospitals is to be recognized as quickly as possible and the system is to be switched over to an…