Passenger lift lighting
- Elevating Systems
- Facility Management
- Ventilation Systems
- Current monitoring
- The function of the lighting in a passenger lift is monitored. If all lights fail, the lift may no longer be used.
- The E3IM is configured with the “under” function so that the current from a single lamp will exceed the threshold and trip the output relay. If the last lamp in a lift car fails, it may not be operated for legal reasons. The current monitoring relay provides this “zero current detection”.
- - Meets the legal requirements by detecting lamp failures
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Safe grid separation for photovoltaic systems
Grid and system protection from TELE safely separates photovoltaic systems from the grid in the event of a fault. The unit is programmable, making it suitable…
Loading docklight control
The light on the loading dock and in the warehouse is often on all night even though no one needs it.
Manure removal systememergency stop
Monitoring of the manure removal system. The conveyor system must switch off when it is blocked by animals or a stoppage.
Furnace feed screw
Sequential control of 2 feed screws for a wood chip heating system.
Monitoring emergency lighting system
An undervoltage monitoring relay with a fixed switching threshold at 0.85% of the nominal voltage is needed for emergency lighting systems. Two changeover…
Prevent elevator shaft from water damage
The TELE Pegelmonitor V4LM4S30 protects elevators and escalators from water water damage.