Panel heating monitoring
- Facility Management
- Heating Control Systems
- Current monitoring
- E1IU5AAC01 230VAC
- Data sheet:
- Monitoring of panel heaters for failure.
- The panel heater is monitored for defects or failure by monitoring the current draw. As long as the panel heater is switched on and is functioning properly, it will consume more electricity than the threshold configured in the monitoring relay. If the power draw falls below the threshold because of a defect, the relay contact trips and indicates a fault.
- - Minimisation and prevention of downtime and faulty lots
- Compact unit
- The low-cost monitoring relay prevents production stoppages, which would cost significantly more
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Power source switchover
When the voltage falls below 0.85 times the nominal voltage for longer than 0.5 seconds, the system must switch over from the normal power supply to the…
Burner process control
A temperature limiter is installed in the process controller of a burner. When it is triggered, a fault message should be sent and maintained after the power is…
Lift equipment service
A wide range of different control and supply voltages are used for conveyor and transport systems. The maintenance of expensive inventories of replacement parts…
Emergency power monitoring
Phase failure for the operating theatre ventilation systems in hospitals is to be recognized as quickly as possible and the system is to be switched over to an…
With the TELE voltage monitoring device critical electrical states such as undervoltage, asymmetry and phase failure are easily detected.
Emergency power supply
It must be ensured that the emergency power system is switched on within 30 ms when the lighting power supply fails.