Optimising energy consumption
- Renewable Energy
- Optimised use of energy from a photovoltaic system.
- The goal is to optimally use the energy generated by a photovoltaic system and not feed surplus energy into the grid. A G2IA15A 4…20mA is connected downstream from the inverter and measures the current that is generated. The analogue value of the output is linked with the control electronics of a heat pump. A hot water buffer tank is heated depending on how much energy is available.
- - Optimised own consumption of the energy generated by a photovoltaic system
- Precise current measurement and processing of the recorded signal
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Monitoring of the operating state of the belt scraper. The belt scraper could get blocked. This can cause the drive chain to become damaged or break.
Catching the sun!
The most important but also basic task for a PV installation is to get the most solar energy converted by the modules. With just two inputs and NO CONTACTORS…
Correct phase sequence and defined shutdown in the event of undervoltage.
Safe grid separation for small hydroelectric power plants
Grid and system protection from TELE safely separates small hydroelectric power plants from the grid in the event of a fault. The unit is programmable, making…
Supply voltage monitoring
Monitoring the supply voltage of an office complex to detect a power failure.
Rotation direction monitoring for heat pumps
A heat pump should be protected against rotation in the wrong direction. If the phase sequence is incorrect, the pump must not be switched on. If a phase fails…