Metering pump dry running protection
- Conveyor Belts
- Industrial Plant
- Load monitors
- The metering pumps in a paint production plant should be prevented from running dry.
- The use of load monitors alone is not possible because the loads vary depending on the temperature and the medium, and the load monitors would have to be continuously reconfigured. The analogue signal from the G2BA400V12A combined with the temperature and medium type allow the customer to create a profile in the PLC and to thereby provide dry running protection.
- - Early detection of dry running, and prevention of possible pump damage
- Motor protection
- Minimisation and prevention of downtime through monitoring
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Wine press monitoring
In wine presses, phase sequence faults and phase failures cause serious problems and damage.
Short-circuit protectionfor shaft furnaces
The short-circuit proof Gefran thyristor controller from TELE increases the availability of plant furnaces, such as a shaft furnaces for gaseous nitriding.
In a meat processing plant, a fluid is to be injected into the meat for a certain period of time at certain intervals.
Industrial vacuum filter cleaning
The filters in industrial vacuums become clogged after a time. The vacuum is run in alternating suction and pressure mode to clean the filter.
Save stove shut down
Time relais avoids unsafe condition in case of impact button blockade E1ZM10 24-240 To avoid fire hazard, the stove in the shared kitchen of a residential home…
Conveyor belt monitoring
A conveyor belt must be stopped rapidly in the event of a blockage with small packages. However, unnecessary downtime must be avoided if at all possible.