Mains failure monitoring
- Emergency Power
- Facility Management
- Renewable Energy
- The emergency lighting is activated in the event of a mains failure or undervoltage.
- The mains failure is monitored with a E3YF400V02 (three phases). If the voltage falls below 85% of the nominal voltage, the output relay trips and turns the emergency lights on.
- - Detects mains failure
- Fulfils the VDE 0100-718 and VDE 0108-100 standards
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Voltage dip detection
Very short voltage dips cause some components in a heating control system to fail, while others continue to function. This interrupts the control circuit, and…
Door contact monitoring
Monitoring doors/door contacts at remote buildings (dock sheds) to detect unauthorised opening
Fountain fill level
The fill level must be monitored in fountains so that the water pump can be activated when the water level is too low.
Leak detection, defective pipes
V4LM4S30 24–240V AC/DC Artikel Nr.: 2104500 Leaks in water tanks or pipes for water, water-soluble liquids or cleaning lyes usually cause serious damage in…
Power source switchover
When the voltage falls below 0.85 times the nominal voltage for longer than 0.5 seconds, the system must switch over from the normal power supply to the…
Safe grid separation for photovoltaic systems
Grid and system protection from TELE safely separates photovoltaic systems from the grid in the event of a fault. The unit is programmable, making it suitable…