Loading docklight control
- Product category:
- Timing Relays
- Building Systems
- Facility Management
- The light on the loading dock and in the warehouse is often on all night even though no one needs it.
- By adding a timer function to the impulse switch, the switch is reset automatically when the user does not turn the lights off.
- - Lower energy costs
- Longer lamp service life
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Lamp monitoring in lifts
A current monitoring relay is needed for direct and rotary current with a measuring range from 10 mA to 10 A. The functions should include overcurrent and…
Emergency power monitoring
Phase failure for the operating theatre ventilation systems in hospitals is to be recognized as quickly as possible and the system is to be switched over to an…
Voltage dip detection
Very short voltage dips cause some components in a heating control system to fail, while others continue to function. This interrupts the control circuit, and…
Prevent elevator shaft from water damage
The TELE Pegelmonitor V4LM4S30 protects elevators and escalators from water water damage.
Power source switchover
When the voltage falls below 0.85 times the nominal voltage for longer than 0.5 seconds, the system must switch over from the normal power supply to the…
Fan monitoring for paint or sandblast booth
The TELE load monitor GAMMA G2CU400V10AL10 recognizes faulty operating conditions of fan motors and triggers the delay timer.