Lathe chip conveyor
- Chip Conveyor
- Industrial Plant
- System shutdown in the event of overload and blockage.
- Chip conveyors are used with machine tools like lathes to transport the cuttings away from the machine. The current monitoring relay recognises an increase in the power drawn by the drive motor as an increase in the load on the conveyor system, and switches the conveyor off quickly and reliably in the event of overload or blockage.
- - Longer chip conveyor service life
This might be of interest for you
No entries found.
Industrial vacuum filter cleaning
The filters in industrial vacuums become clogged after a time. The vacuum is run in alternating suction and pressure mode to clean the filter.
Short-circuit protectionfor shaft furnaces
The short-circuit proof Gefran thyristor controller from TELE increases the availability of plant furnaces, such as a shaft furnaces for gaseous nitriding.
Backdrop and light hoist
The overloading of theatre backdrop and light hoists should be prevented.
Electronic load shedding relay prevents overloads
TELE relais prevents operation of more than one high-load consumer at a time E1IM10AACL10 When running several electrical consumers simultaneously, such as…
Conveyor belt monitoring
A conveyor belt must be stopped rapidly in the event of a blockage with small packages. However, unnecessary downtime must be avoided if at all possible.
Mobile communications transmitter station
System faults and failures in mobile communications transmitter stations as a result of poor power supply quality (undervoltage, phase failure) should be…