Lamp failure detection
- Elevating Systems
- Facility Management
- Current monitoring
- Lamp failure detection in a lift car.
- Monitoring of the permitted current range of the lighting with the “under” function.
As soon as the power draw leaves the acceptable range, for example because of a load reduction due to a defective lamp, the relay output is tripped, and the higher-level control system can recognise the fault.
- - Rapid fault detection, quick replacement possible
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
No flooding in the underground car park
The V4LM level monitor controls the entry of water into underground car parks and activates pumps to pump out the water as well as issue alarm signals as…
Manure removal systememergency stop
Monitoring of the manure removal system. The conveyor system must switch off when it is blocked by animals or a stoppage.
Burner process control
A temperature limiter is installed in the process controller of a burner. When it is triggered, a fault message should be sent and maintained after the power is…
Door contact monitoring
Monitoring doors/door contacts at remote buildings (dock sheds) to detect unauthorised opening
Rotation direction monitoring for heat pumps
A heat pump should be protected against rotation in the wrong direction. If the phase sequence is incorrect, the pump must not be switched on. If a phase fails…
Safe grid separation for photovoltaic systems
Grid and system protection from TELE safely separates photovoltaic systems from the grid in the event of a fault. The unit is programmable, making it suitable…