Grid and systemprotection
- Energy generation
- Compliance with power utility standards and specifications regarding frequency and voltage for feeding power into the public power grid.
- Monitors deviations from the minimum and maximum values for voltage and frequency.
- - Thresholds specified precisely in accordance with the standard
- A single device for voltage and frequency monitoring
This might be of interest for you
No entries found.
Safe grid separation for photovoltaic systems
Grid and system protection from TELE safely separates photovoltaic systems from the grid in the event of a fault. The unit is programmable, making it suitable…
Rotation direction monitoring for heat pumps
A heat pump should be protected against rotation in the wrong direction. If the phase sequence is incorrect, the pump must not be switched on. If a phase fails…
Load status monitoring
The rotor blades of a wind turbine have to be turned out of the wind in the event of a problem. A battery is used for this. Therefore, the battery must be…
Monitoring emergency lighting system
An undervoltage monitoring relay with a fixed switching threshold at 0.85% of the nominal voltage is needed for emergency lighting systems. Two changeover…
Peak load detection
An emergency power generator starts in the event of a mains failure.
Start-up suppression for DC motors
The starting resistor of a DC motor has to be bypassed for regular operations, but no additional control voltage is available.