- Centrifugal Pumps
- Water & Waste
- Power reading converter
- Simple throughput measurement for a centrifugal pump.
- A power reading converter can be used as a simple, low-cost method for measuring the throughput of a centrifugal pump. The power consumption of a centrifugal pump is proportional to the volume being pumped. The measured power can be translated directly into the throughput.
- - Dry running protection can be implemented at the same time
- Nothing needs to be installed in the system
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Current monitoring for pump stations
Plug-in monitoring relays are installed in the pump stations of many hydropower plants. These devices are intended to allow for quick and safe replacement in…
Cleaning the pump impeller through intelligent motor control
Soft starter Christian P-4.0 with integrated forward/reverse control enables automatic cleaning in closed pump system
With the TELE voltage monitoring device critical electrical states such as undervoltage, asymmetry and phase failure are easily detected.
No flooding in the underground car park
The V4LM level monitor controls the entry of water into underground car parks and activates pumps to pump out the water as well as issue alarm signals as…
Energy measurement for wind generators and small hydropower plants
Energy measurement for wind generators and small hydropower plants S6XM50A1000VM und S9XM300A1000VM Wind turbines or small hydropower plants are confronted with…
Dry running protection for submersible motor-driven pumps
Monitoring of household wells so that they are not pumped dry, and to ensure that the pump does not run dry.