- Product category:
- Timing Relays
- Industrial Plant
- Machine Tools
- After the system is switched off, the extraction system should continue to run for a certain time to ensure that no sawdust remains on the machine.
- The D6DQ is used with function R – return delay. The extraction system runs for the specified period of time and removes the sawdust. If the system is switched back on during this time, the elapsed time is reset, and begins again from zero the next time the system is shut down.
- - Save and cheap solution
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
When the lights fail in public buildings (such as schools) because of undervoltage, the emergency lighting systems must be activated in publicly accessible…
Short-circuit protectionfor shaft furnaces
The short-circuit proof Gefran thyristor controller from TELE increases the availability of plant furnaces, such as a shaft furnaces for gaseous nitriding.
Pulp manufacturecurrent measurement
Multiple motors are controlled by a frequency converter. The frequency converter can only measure the total current, but not the power draw of the individual…
Monitoring of a fan motor for V-belt breakage or slippage.
Pulp production datacollection
Monitoring of the production line for cellulose fibre. The operating data for the conveyor belt drive motors must be collected and sent to the higher-level…
Pipe system cleaning
Chemical deposits are to be removed from pipe networks mechanically by means of different compressed air and water pressure impulses.