Energy measurement for wind generators and small hydropower plants
- Hydropower Plants
- Renewable Energy
- Wind Power
- SensAct/ power, energy, current, voltage
- Wind turbines or small hydropower plants are confronted with variable frequencies at alternating current and require measuring instruments that are precisely designed for this purpose.
- The TELE S6XM50A1000VM and S9XM300A1000VM (single-phase power/energy meters) are the perfect meters for small and medium wind turbines or small hydroelectric power plants. Since these systems usually generate alternating current with variable frequency in the range from a few herz to 400Hz, the RMS measuring system of the TELE devices is perfectly suited for this. The Tele S6(9)XM50(300)A1000VM delivers the measured values for power, current, voltage and energy (non-volatile meter memory) in a safely isolated data stream at the ModBus RTU interface. The broadband auxiliary power supply from 9VDC to 30VDC makes it much easier to use in a harsh environment. By digitally measuring the frequency of the AC voltage or current generated, the generator speed can be obtained directly from the energy meter.
- The integrated RS485 interface allows the S6XM50A1000VM to be connected to any ModBus master such as PCs, HMI, PLC, WLAN, modems and Wi-Fi access routers. The S6XM50A1000VM is one of the smallest single-phase power meters on the market and can be easily installed in almost any power distribution system..
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Monitoring of the operating state of the belt scraper. The belt scraper could get blocked. This can cause the drive chain to become damaged or break.
Rotation direction monitoring for heat pumps
A heat pump should be protected against rotation in the wrong direction. If the phase sequence is incorrect, the pump must not be switched on. If a phase fails…
With the TELE voltage monitoring device critical electrical states such as undervoltage, asymmetry and phase failure are easily detected.
Grid and systemprotection
Compliance with power utility standards and specifications regarding frequency and voltage for feeding power into the public power grid.
Supply voltage monitoring
Monitoring the supply voltage of an office complex to detect a power failure.
Safe grid separation for photovoltaic systems
Grid and system protection from TELE safely separates photovoltaic systems from the grid in the event of a fault. The unit is programmable, making it suitable…