Emergency power monitoring
- Emergency Power
- Facility Management
- Renewable Energy
- Voltage monitoring
- Phase failure for the operating theatre ventilation systems in hospitals is to be recognized as quickly as possible and the system is to be switched over to an emergency generator in such an event. The customer wishes to have 2 contacts to signal the use of emergency power immediately.
- This device was used because it reacts to phase failure within 20 seconds and recognises undervoltage and overvoltage.
- - Rapid power supply fault detection according to VDE 0126-1-1
- 2 contacts
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
When the lights fail in public buildings (such as schools) because of undervoltage, the emergency lighting systems must be activated in publicly accessible…
Monitoring of smoke extraction fans
Function monitors should be installed for smoke extraction fans that must run without motor protection, and possibly until they fail, in the event of a fire.
Automated roll gate/sliding gate control
Soft-starter CHRISTIAN P-4.0 with soft start/soft stop prevents the mechanics of roll gates from heavy stress.
Automatic fan control of drying chamber
The monitoring relais E3IF500mAAC20 controls automatic start/stop of auxiliary drives.
Furnace feed screw
Sequential control of 2 feed screws for a wood chip heating system.
Charge measurement for energy storage devices
Save and fully isolated measurement of DC energy packs VEO Series V4IA100A 24-240V AC/DC For battery power packs in energy storage devices, peak power systems…