Door contact monitoring
- Facility Management
- Safety Technology
- Thermistor monitoring
- Monitoring doors/door contacts at remote buildings (dock sheds) to detect unauthorised opening
- Standard door contacts were connected to the measuring circuit of the monitoring relay in series.
When the door is opened, the contact is opened, the resistance of the measuring circuits becomes infinite, and the output relay of the E3TF01 triggers a siren with a lamp.
- - Low-cost technical solution to protect remote buildings against unauthorised entry
- Long sensor cables and galvanic isolation of the measurement circuit and supply circuit
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Burner process control
A temperature limiter is installed in the process controller of a burner. When it is triggered, a fault message should be sent and maintained after the power is…
Automated roll gate/sliding gate control
Soft-starter CHRISTIAN P-4.0 with soft start/soft stop prevents the mechanics of roll gates from heavy stress.
LED lamp monitoring
LED lamps nowadays are widely used in buildings, industrial environment, plants and public places. The challenging task to monitor changes in the low lamp…
Re-cooling system monitoring
The overloading of the re-cooling systems in a data centre is prevented.
Rotation direction monitoring for heat pumps
A heat pump should be protected against rotation in the wrong direction. If the phase sequence is incorrect, the pump must not be switched on. If a phase fails…
Prevent elevator shaft from water damage
The TELE Pegelmonitor V4LM4S30 protects elevators and escalators from water water damage.