Current monitoring for pump stations
- Hydropower Plants
- Renewable Energy
- Water & Waste
- Plug-in monitoring relays are installed in the pump stations of many hydropower plants. These devices are intended to allow for quick and safe replacement in the event of problems. The relay monitors the current draw of the pump.
- Multifunction 11-pole current monitoring relays are used. These devices are also suitable for connection with older devices and can be quickly replaced thanks to the socket.
- - Multifunction
- Reduces inventory costs because a single device replaces several previous models.
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Door contact monitoring
Monitoring doors/door contacts at remote buildings (dock sheds) to detect unauthorised opening
With the TELE voltage monitoring device critical electrical states such as undervoltage, asymmetry and phase failure are easily detected.
Rotation direction monitoring for heat pumps
A heat pump should be protected against rotation in the wrong direction. If the phase sequence is incorrect, the pump must not be switched on. If a phase fails…
Safety shutdown for wind turbines
It is crucial for the rotor blades of a wind power plant to be turned out of the wind when the turbine is shut down in order to prevent the system from being…
Safe grid separation for small hydroelectric power plants
Grid and system protection from TELE safely separates small hydroelectric power plants from the grid in the event of a fault. The unit is programmable, making…
Optimising energy consumption
Optimised use of energy from a photovoltaic system.