Crane obstruction lighting
- Other Applications
- Current monitoring
- The function of obstruction lighting on a construction crane should be monitored.
- The function of the obstruction lighting on a crane is monitored with a current monitor using the “under” function.
As soon as the power draw leaves the acceptable range, for example because of a load reduction due to a defective lamp or circuit breaker, the relay output is tripped, and the higher-level control system can recognise the fault.
- - Ensuring the functioning of the legally required obstruction lighting through fast and low-cost monitoring that can be retrofitted easily.
- Simple to set up
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Pipe system cleaning
Chemical deposits are to be removed from pipe networks mechanically by means of different compressed air and water pressure impulses.
Grain storage ventilation system
The drive motor of a mixing feed screw in a grain storage facility is to be protected against incorrect phase sequences when it is connected to the power…
With the TELE voltage monitoring device critical electrical states such as undervoltage, asymmetry and phase failure are easily detected.
Current monitoring for pump stations
Plug-in monitoring relays are installed in the pump stations of many hydropower plants. These devices are intended to allow for quick and safe replacement in…
Monitoring of supply pumps
Ensuring the correct rotation direction for the supply pump in a hydropower plant.
Energy measurement for wind generators and small hydropower plants
Energy measurement for wind generators and small hydropower plants S6XM50A1000VM und S9XM300A1000VM Wind turbines or small hydropower plants are confronted with…