Circuit board cleaning
- Cleaning, Washing
- Industrial Plant
- Power reading converter
- The pressure applied by the cleaning brush for cleaning circuit boards should remain as constant as possible to ensure optimal results.
- When the pressure increases, the power drawn by the brush motor also increases. The use of a power measuring transducer forwards the power consumption of the brush motor to the PLC over a standard signal (4–20 mA), and the PLC then adjusts the position of the brush accordingly with an actuator.
- - The solution offers the required rapid reaction
- Mechanical solution too expensive and complicated
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Fill level monitoring
The seizing of float switches in fluids of certain consistencies or float switches becoming caught on foreign objects precludes the use of a mechanical…
Pulp production datacollection
Monitoring of the production line for cellulose fibre. The operating data for the conveyor belt drive motors must be collected and sent to the higher-level…
Pulp manufacturecurrent measurement
Multiple motors are controlled by a frequency converter. The frequency converter can only measure the total current, but not the power draw of the individual…
Mobile communications transmitter station
System faults and failures in mobile communications transmitter stations as a result of poor power supply quality (undervoltage, phase failure) should be…
Save stove shut down
Time relais avoids unsafe condition in case of impact button blockade E1ZM10 24-240 To avoid fire hazard, the stove in the shared kitchen of a residential home…
Feed pump monitoring
The feed pump at a natural gas fuel station must be monitored for dry running. If no LNG is being pumped, the pump must be switched off.