- A charging unit for forklifts is to be protected against overheating. The charging current is high at the beginning of the charging process, and the charger is to be cooled with a fan.
- On the primary side, the current consumption of the charger is monitored. If the set threshold is exceeded, the output relay is tripped and switches the fan on. When the charging current falls (maintenance charge), the fan is switched off.
- - Simple implementation
- Protects the charger
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
No flooding in the underground car park
The V4LM level monitor controls the entry of water into underground car parks and activates pumps to pump out the water as well as issue alarm signals as…
Monitoring of the operating state of the belt scraper. The belt scraper could get blocked. This can cause the drive chain to become damaged or break.
Safe grid separation for small hydroelectric power plants
Grid and system protection from TELE safely separates small hydroelectric power plants from the grid in the event of a fault. The unit is programmable, making…
Sewage plant rake drive
The goal is to monitor a sewage plant rake for overload, and to switch it off when it is blocked by large pieces of wood.
Fountain fill level
The fill level must be monitored in fountains so that the water pump can be activated when the water level is too low.
Pump control to reduce water hammering in the pipe system
Christian P-4.0 with soft start and soft stop increases the water pressure in the pipe in a controlled way. The pump does not generate water hammering the pipes…