Burner process control
- Building Systems
- Facility Management
- Ventilation Systems
- Thermistor relay
- A temperature limiter is installed in the process controller of a burner. When it is triggered, a fault message should be sent and maintained after the power is switched off.
- The cable breakage monitoring function of the thermistor relay monitors the status of the temperature limiter.
In the event of a fault, the output relay is tripped, and the fault is signalled through the output contact. The only way to clear the fault is to press a reset button.
The state of the output relay is also saved in the event of a power supply interruption. When the power supply is restored, the state from before the power failure is restored, and the fault is not cleared until the internal or external reset button is pressed.
- - Complicated conventional control system is replaced with a relay.
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
LED lamp monitoring
LED lamps nowadays are widely used in buildings, industrial environment, plants and public places. The challenging task to monitor changes in the low lamp…
Lift equipment service
A wide range of different control and supply voltages are used for conveyor and transport systems. The maintenance of expensive inventories of replacement parts…
Lamp monitoring in lifts
A current monitoring relay is needed for direct and rotary current with a measuring range from 10 mA to 10 A. The functions should include overcurrent and…
With the TELE voltage monitoring device critical electrical states such as undervoltage, asymmetry and phase failure are easily detected.
Door contact monitoring
Monitoring doors/door contacts at remote buildings (dock sheds) to detect unauthorised opening
Loading docklight control
The light on the loading dock and in the warehouse is often on all night even though no one needs it.