Building navigation lights
- Facility Management
- Current monitoring
- LED navigation lights on taller buildings and towers in the vicinity of airports should be monitored. A contact should be tripped when the power draw falls below the set power draw for a given lamp wattage. Different power draws from 10 mA to 5 A are needed.
- Different thresholds can be set in the current monitoring relay depending on the wattage of the lamps. Both in the ampere range and in the milliampere range.
- - One device for multiple configurable thresholds
- Lower inventory costs as a result
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Burner process control
A temperature limiter is installed in the process controller of a burner. When it is triggered, a fault message should be sent and maintained after the power is…
Passenger lift lighting
The function of the lighting in a passenger lift is monitored. If all lights fail, the lift may no longer be used.
Rotation direction monitoring for heat pumps
A heat pump should be protected against rotation in the wrong direction. If the phase sequence is incorrect, the pump must not be switched on. If a phase fails…
With the TELE voltage monitoring device critical electrical states such as undervoltage, asymmetry and phase failure are easily detected.
Continuous operation detection
Preventing the destruction of a compressor due to continuous operation after an air hose becomes defective.
Fountain fill level
The fill level must be monitored in fountains so that the water pump can be activated when the water level is too low.