Bandsaw splitting machine
- Product category:
- Timing Relays
- Industrial Plant
- Machine Tools
- Sharpening of a bandsaw.
- A bandsaw splitting machine is used where blocks and panels of rubber and PE foam are to be cut in half or into thin layers.
The bandsaw is sharpened with a sharpening device after a certain number of cuts. This is controlled by the D6DI clock generator. The cuts are completed in the pause of 120 sec, and the bandsaw is sharpened in the impulse period of 10 sec.
- - Simple and low-cost control of the sharpening of the bandsaw with a single timing relay
May I help you?
Can't find what you're looking for? Please don't hesitate to contact me.
This might be of interest for you
No entries found.
Short-circuit protectionfor shaft furnaces
The short-circuit proof Gefran thyristor controller from TELE increases the availability of plant furnaces, such as a shaft furnaces for gaseous nitriding.
Circuit board cleaning
The pressure applied by the cleaning brush for cleaning circuit boards should remain as constant as possible to ensure optimal results.
Backdrop and light hoist
The overloading of theatre backdrop and light hoists should be prevented.
Feed pump monitoring
The feed pump at a natural gas fuel station must be monitored for dry running. If no LNG is being pumped, the pump must be switched off.
Frequency converter control
A frequency converter controls a conveyor belt motor. The frequency converter is controlled by a 4–20 mA signal from a PLC. Monitoring of a 4–20 mA control…
Baking cabinet exhaust fan
The functioning of the exhaust fan in a baking cabinet must be monitored. When no air is being moved, for example because the impeller is damaged, a fault…