- Processing machines
- The consistency of the material to be agitated should remain constant.
- When the consistency of the material to be agitated changes, the power consumption of the agitator motor increases. The use of a power measuring transducer forwards the power consumption of the agitator motor to the PLC over a standard signal (4–20 mA), and the PLC then adjusts the consistency by adding fluid.
- - Rapid reaction, independent of the medium (aggressive, explosive, etc.)
- Mechanical solution much too expensive and complicated
This might be of interest for you
No entries found.
Circuit board cleaning
The pressure applied by the cleaning brush for cleaning circuit boards should remain as constant as possible to ensure optimal results.
Electric winch monitoring
An electric winch should be protected against overload.
Bandsaw splitting machine
A bandsaw splitting machine is used where blocks and panels of rubber and PE foam are to be cut in half or into thin layers.
Train washing system
The pressure applied by the cleaning brush in a train washing system should remain as constant as possible to ensure optimal cleaning.
Plastic contour cutting machine
Switching on additional ventilation of a frequency-controlled drive motor on a contour cutting machine for plastic.
Conveyor belt monitoring
A conveyor belt must be stopped rapidly in the event of a blockage with small packages. However, unnecessary downtime must be avoided if at all possible.